Now loosen the 10mm bolt on the hose clamp that secures the turbo inlet tube to the MAF sensor housing and you should be able to lift the factory air box and MAF sensor housing up and out. SKU: ETS_EVOX_INT The ETS MAF Intake Includes a huge 5" inlet K+N air filter which feeds the intake pipe via the ETS EVO X MAF adapter which is milled on the ETS lathe for the perfect transition to the inlet diameter of the MAF sensor tube.
#K and n air filter reviews upgrade#
Silver MAF housing - RACE NPBoosted 6+6 Turbo Billet Compressor Wheel Upgrade FOR 2008-2016 Mitsubishi Lancer EVO Evolution 10 X TD05H 152G6 47/68mm Fits OE Size Turbocharger Housing Fitment Guide: 4B11 2. With a built in dowel pin and precise inner diameter to make a 100% seal with the rubber grommet, this piece installs and fits as if it had a Mitsubishi part nu AMS Short Ram Intake w/ MAF Housing& Breather Bung – Evo 8/9 $ 290. The larger MAF housing cross section does two things. I paid over $300 bucks for this and come to find out, all I needed to do was clean off the MAF sensor because the oil had covered it up and was causing the computer to think that the car wasn't receiving the efficient amount of air flow.Evo x maf housing Mitsubishi OEM Mass Air Flow Sensor O-Ring for Evo X (MN137122) $4. This is what prompted them into replacing the MAF sensor and wiring. The technician explained to me that the signal circuit wire that runs from the computer to the MAF sensor was fluctuating and not keeping the 5 volts. I find this out, however, after I paid to have a new Mass Air Flow Sensor installed and wiring. Come to find out, the oil from the K&N air filter had came off and covered my Mass Air Flow Sensor which had caused all the problems in which my car was experiencing. I had gone to Auto Zone about a year after installing the air filter and had a diagnostic test performed and it came back as a P0101. I had 3 transmission specialists look at it and their response was that the transmission was going out. About 6 months after installing the air filter, my car began to hesitate when shifting gears. It was almost immediate, when I noticed that my car decreased in gas mileage (23 to 16 miles per gallon). I purchased a Fram air filter and cleaned off the MAF sensor and now my car runs fine! I have nothing good to say about this K&N air filter and I wouldn't advice anybody else to waste their money! I paid over $300 bucks for this and come to find out, all I needed to do was clean off the MAF sensor because the oil had covered it up and was causing the computer to think that the car wasn't receiving the efficient amount of air flow.